Profitec 400 Control Unit

My machine was down for two weeks waiting on this part, and I'm just relieved the swap was so straightforward. The board seated perfectly into the existing harness, and now all the buttons and PID readouts respond exactly as they should. Took about twenty minutes with a screwdriver and a lot of pati

Replaced the fried original board in my Profitec 400, and this genuine part fit perfectly with no wiring issues. The machine is back to pulling consistent shots, and the control panel responds just like new.

Swapped this in after a power surge fried the old board, and my machine fired right up on the first try. The connectors lined up perfectly with the wiring harness, making the install a quick twenty-minute job. Glad I went with the genuine part instead of gambling on an off-brand module.